It is necessary to avoid "throwing away"
Display Micro Screws after they are scrapped, and a full life cycle traceability system should be established to realize resource recycling.
Metal recycling: After scrapped Display
Micro Screws are dismantled, the metal parts are sent to professional recycling companies for smelting and remade into mold steel, with a recovery rate of more than 95%; rare metals (such as tungsten in tungsten steel) are extracted through extraction technology for secondary use.
Non-metal recycling: rubber seals and plastic parts are converted into fuel oil or chemical raw materials through pyrolysis treatment; ceramic parts are classified and recycled for use in building materials or grinding materials.
Data from an industry association shows that a complete recycling system can increase the resource recycling rate of the mold industry to more than 70% and reduce solid waste emissions by approximately 50,000 tons per year.
The green management of Display Micro Screws is not a single link improvement, but a full life cycle system engineering.
From the implantation of environmentally friendly genes at the design source, to the full-process optimization of materials, manufacturing, operation and maintenance, to closed-loop recycling after scrapping, every step requires collaborative advancement between enterprises and the industry chain.
In the future, with the development of digital technology (such as digital twins) and new materials (such as bio-based composite materials), green management will be more intelligent and efficient.
Only by adhering to equal emphasis on environmental protection and efficiency can we achieve the sustainable development of the Display Micro Screws industry and help the manufacturing industry transform into "green manufacturing".
