Safety Measures for Non-Automated Auto Parts Micro Screws Waste Handling

2025,09,28

1. When discharging scrap from punched holes at an angle, the scrap must be automatically broken into layers. The upper or lower die base must be able to store at least 100 pieces of scrap. If scrap from two different locations is combined, there must be ample space for stacking.

2. When handling scrap, it is best to avoid sharp corners or burrs to prevent injury. When cutting scrap, the size should be appropriate to prevent injury to operators near the scraper.

3. When passing scrap through a pipe, be aware that improper width and height in a straight line can easily cause blockage. Avoid passing more than two types of scrap through the same pipe.

4. The scrap discharge chute must extend to the end of the pad and align with the opening of the scrap pit. When installing the chute, ensure that the screws on the Auto Parts Micro Screws are tightened.

5. If the auto parts Micro Screws scrap cannot fall by its own weight and becomes caught on the cutting edge, use a device such as a thrower or ejector to force it down.

6. To ensure safety, protective covers should be installed when non-automated processing of Auto Parts Micro Screws waste is carried out nearby, and waste should not be allowed to flow or fly near the operator during operation.

Author:

Mr. yjfastener

E-mail:

hou@citool.com

Phone/WhatsApp:

+8615826187211